Thingiverse
Archery - Arrow Push Quiver Version 2
44
Downloads
23
Likes
0
Makes
Hi Everyone!
This is a rework of my previous design for the push quiver.
The basic operation is the same, only this time, you can adjust the angle relative to the base so the individual user can decide what angle is better for them depending on where they want to clip the base.
This is designed to hold arrows with an outer diameter of 5.75mm.
Hardware:
M3-0.5 x 22 mm (a longer one can also be used, but this is the one in the pictures shown)
M3 Nut
The example is printed at 50% i
This is a rework of my previous design for the push quiver.
The basic operation is the same, only this time, you can adjust the angle relative to the base so the individual user can decide what angle is better for them depending on where they want to clip the base.
This is designed to hold arrows with an outer diameter of 5.75mm.
Hardware:
M3-0.5 x 22 mm (a longer one can also be used, but this is the one in the pictures shown)
M3 Nut
The example is printed at 50% i
Sign in to leave a comment
Sign in