Thingiverse
Piseeks box
by igng
18
Downloads
16
Likes
0
Makes
Hi, I'm Mr. Piseeks, look at me!
---
This is a Raspberry Pi 3 case, based on the Meeseeks' Box, from "Rick and Morty". It is a 10cm cube, slightly bigger than the RPi. The side panel has the micro-USB, HDMI and jack ports at the bottom, while in the middle there is a hole for the GPIO pins. The rear (or front, it is up to you) has the "Ethernet+4USB" ports.
It's still a WIP, I'm deciding if modify it to make it fit the RPi leaving no room inside, or leave it as a cube (I'll probably mak
---
This is a Raspberry Pi 3 case, based on the Meeseeks' Box, from "Rick and Morty". It is a 10cm cube, slightly bigger than the RPi. The side panel has the micro-USB, HDMI and jack ports at the bottom, while in the middle there is a hole for the GPIO pins. The rear (or front, it is up to you) has the "Ethernet+4USB" ports.
It's still a WIP, I'm deciding if modify it to make it fit the RPi leaving no room inside, or leave it as a cube (I'll probably mak
Sign in to leave a comment
Sign in