Thingiverse
Prusa i3 MK2 - Linear Advance Calibration
by 3druck_com
48
Downloads
25
Likes
0
Makes
Two testfiles that allow you to callibrate Linear Advance for your Prusa i3 MK2 3D-Printer.
For using Linear Advance you will need the so calles "K-Factor", deppending on your Material the needed factor will be between 0 and 100. For PLA good values are between 35 and 50.
The test files will creates a few lines in ascending order. Both files start with a K value of 0 and then a step size of 5 or 10 (depending on the used file). The whole test only works with the the most recent firmware,
For using Linear Advance you will need the so calles "K-Factor", deppending on your Material the needed factor will be between 0 and 100. For PLA good values are between 35 and 50.
The test files will creates a few lines in ascending order. Both files start with a K value of 0 and then a step size of 5 or 10 (depending on the used file). The whole test only works with the the most recent firmware,
Sign in to leave a comment
Sign in