Thingiverse
Circular Knitting Needle 10mm
by W4YBO
63
Downloads
50
Likes
0
Makes
What up, my knitters!
10mm x 125mm knitting needles with a hole at the rear for gluing in an appropriate length of 1.75mm PCTPE filament.
After printing, ream out the cross hole, then the rear hole with a #47 or 2mm bit. Chuck a needle up in a drill to sand (400 grit) it smooth. A dab of superglue will seat the PCTPE in the rear hole. Use PCTPE or Nylon since most other filaments become brittle as they absorb moisture from the air. The needles can be printed out of your favorite filame
10mm x 125mm knitting needles with a hole at the rear for gluing in an appropriate length of 1.75mm PCTPE filament.
After printing, ream out the cross hole, then the rear hole with a #47 or 2mm bit. Chuck a needle up in a drill to sand (400 grit) it smooth. A dab of superglue will seat the PCTPE in the rear hole. Use PCTPE or Nylon since most other filaments become brittle as they absorb moisture from the air. The needles can be printed out of your favorite filame
Sign in to leave a comment
Sign in