Tie Bar For Traxxas Stampede

This is a tie bar for the Traxxas Stampede front end. I know you can buy a fiberglass or aluminum one, but I decided to design one in TinkerCAD. I have not tried out on the RC vehicle yet. PLA printed at 100% infill for strength. Takes about 10 minutes to print on my Anet A8. This is a small print so make sure your nozzle height is set right. If the nozzle is a bit too high, the ends will curl up slightly and will make in thinner where the mount holes are.
I added the raised letter Stampe