Thingiverse
Hot end mounted Z-Probe
by bequdrei
17
Downloads
3
Likes
0
Makes
This is my approach to a manually deployable Z probe for the TEVO Tarantula.
It will allow you to change your build plate without reconfiguring the z-offset every time. The design is far from perfect but an easy print and in my opinion quite helpful.
**Beware of the fact that your printer will crash right into the build plate when you forget to deploy the sensor!**
The necessary z-offset depends on the exact placement of the mount. In my case it is -12.9mm. To calibrate your printer to
It will allow you to change your build plate without reconfiguring the z-offset every time. The design is far from perfect but an easy print and in my opinion quite helpful.
**Beware of the fact that your printer will crash right into the build plate when you forget to deploy the sensor!**
The necessary z-offset depends on the exact placement of the mount. In my case it is -12.9mm. To calibrate your printer to
Sign in to leave a comment
Sign in