Furry Hexmas Tree (single and dual extrusion)

Merry Christmas!

Print without supports, minimal infill (I used 5%) Both versions included, single and dual extrusion.

I printed 2 trees, one at 0.2mm and the green one at 0.3, the purple one probably printed a bit better at 0.2 but both came out fine. I ran 2 shells on the green, 3 shells on the purple, 3 shells had less casualties on the branches when removing the cone.

There was a few ways I thought about doing a hairy tree, many of the attempts at branches and fancy things just yiel