Thingiverse
LED Strip Holder
by ltlowe
48
Downloads
20
Likes
0
Makes
Holder for 13.5mm x 77mm x 4.25mm LED strip.
Designed to stick on with double sided tape or command strip and move up and down with the Z carriage on the right side of an AnyCubic i3 Mega, but there is nothing printer specific about it.
I wanted an angled eye shield, so decided to add a second holder on an angle that could double as the shield. I'm only using one strip, but two fit perfectly as shown in the pictures.
For the AnyCubic, I ran wires to an unused 12V source on the main power
Designed to stick on with double sided tape or command strip and move up and down with the Z carriage on the right side of an AnyCubic i3 Mega, but there is nothing printer specific about it.
I wanted an angled eye shield, so decided to add a second holder on an angle that could double as the shield. I'm only using one strip, but two fit perfectly as shown in the pictures.
For the AnyCubic, I ran wires to an unused 12V source on the main power
Sign in to leave a comment
Sign in