Thingiverse
Hatchbox Filament Plug
by geckogizmo
50
Downloads
36
Likes
0
Makes
This plug was designed for Hatchbox 1.75 PLA may work with others.
I was using other "Clips" but they kept flying off so I designed this plug. It is pretty tight - so it has a better chance to not fall off. Note that not all holes in the reel are the same size. I found two on my test reel that are too small for the plug. If you can't get it through the hole from the inside, insert it from the outside then try to insert it from the inside again.
Snip any melted/deformed filament from
I was using other "Clips" but they kept flying off so I designed this plug. It is pretty tight - so it has a better chance to not fall off. Note that not all holes in the reel are the same size. I found two on my test reel that are too small for the plug. If you can't get it through the hole from the inside, insert it from the outside then try to insert it from the inside again.
Snip any melted/deformed filament from
Sign in to leave a comment
Sign in