Anycubic I3 Mega Filament Guide

*Update - I found this to be fine on half spools but when the spool is full could do be with being a bit longer. Extended by 20mm v5 uploaded- also added some more depth to the hole for the PTFE tube.

I wanted to tidy up the feed into the Bowden drive so made this, Thought I would share

The first one was for a 4mm Pneumatic fitting, but the brass edge shaved the filament as it fed in.

So I glued in a plastic coupling instead but hated the Botch job

Remade with a built-in feed hole.