Samsung remote holder w/o screws version 1

I remixed the "remote control holder with screws" for mounting it under the table with some double sided sticky tape.
This version is for mounting on smaller surface.
I changed the design a bit to print it on the back without the need of supports.

Print Settings

Infill: 20%

Raft: no

Support: no

Layer: 0,2mm

Nozzle: 200°

Bed: 60°

Used Filament:
http://amzn.to/2lzVd9q

Super sticky tape (fully removable and really strong):
http://amzn.to/2CA0cRN

I always use the fo