Thingiverse
Fan Duct for Anycubic i3 Mega with V6 Hotend and Sensor Holder
by derhopp
85
Downloads
33
Likes
0
Makes
This is a fan duct for the Anycubic i3 Mega with a V6 hotend. The fan duct can hold a capacitive or inductive sensor. This fan duct gives a good downward cooling without affecting the heater block.
The V6 hotend must be connected *directly* without spacer.
You simply stick in the fan in the opening. I use the following fan: https://www.amazon.com/UEETEK-Printer-Cooling-Cooler-Heatsinks/dp/B06XDS15W1
The sensor clip holds a 12mm capacitive or inductive sensor.
You can use the origin
The V6 hotend must be connected *directly* without spacer.
You simply stick in the fan in the opening. I use the following fan: https://www.amazon.com/UEETEK-Printer-Cooling-Cooler-Heatsinks/dp/B06XDS15W1
The sensor clip holds a 12mm capacitive or inductive sensor.
You can use the origin
Sign in to leave a comment
Sign in