Thingiverse
Li-PO Battery holder
by uldtot
8
Downloads
4
Likes
0
Makes
Battery holder for a 7.4 Li-PO battery (Width and height easychangeable in tinkerCAD to fit most battery sizes). Will be used on a RC Rock crawler to make batteries sit on the site insead of the top.
Design is made to work with zip ties and have enough space if drilling and using screws is wanted.
This is a tight fit design, instead battery from top and to remove push on the back and take out from front. Stopper at the back to avoid battery sliding out.
** Note **
Not yet printed thi
Design is made to work with zip ties and have enough space if drilling and using screws is wanted.
This is a tight fit design, instead battery from top and to remove push on the back and take out from front. Stopper at the back to avoid battery sliding out.
** Note **
Not yet printed thi
Sign in to leave a comment
Sign in