Micro SD Card Holder For Creality CR10

You need two screws m4-0.7 x 25mm, you will have to ream or clean the two 4mm holes on the main body after printing.

Usb port is still accessible.

The smaller piece slips into the main body and locates off the back edge of the main part, the reader then lays inside the new piece and gets sandwiched between the CR10 control box and the part once it is mounted.

The reader I remixed this for is from amazon, its a lanmu micro Sd to microSd with a 48cm ribbon cable. http://a.co/0LQcFJy