Thingiverse
HyperLite Superstrong Pod
by Engineer_Fpv
27
Downloads
20
Likes
0
Makes
For the hyperlite evo/ss
Must print in TPU
m3 screws with 7-10mm long( can use m3 nuts, i never actually did).
I have been using a unify vtx and i have my antenna(aomway) inside the pod, you can use any antenna as you like with a pigtail, or you can have in on the bracket as stock.
Foxeer hs1177 camera mounted with the U bracket in the middle screw.
2.5mm foxeer lens.
The lens/camera are fully protected from the pod and no surroundings
It took some really good crashes, Super strong
St
Must print in TPU
m3 screws with 7-10mm long( can use m3 nuts, i never actually did).
I have been using a unify vtx and i have my antenna(aomway) inside the pod, you can use any antenna as you like with a pigtail, or you can have in on the bracket as stock.
Foxeer hs1177 camera mounted with the U bracket in the middle screw.
2.5mm foxeer lens.
The lens/camera are fully protected from the pod and no surroundings
It took some really good crashes, Super strong
St
Sign in to leave a comment
Sign in