Pi ZeroW exterior frame mount for Prusa MK3

For externally mounting the Raspberry Pi Zero W board to the rear of the Einsy enclosure of a Prusa i3 MK3 3D printer. Printed in PLA. This is a dimensional part so your printer must be setup to print accurately. Must remove four vent crossbars on the enclosure. You will need two 3mm x 8mm long phillips flat head screws and two 3mm hex nuts OR two #4-40 x 5/16" long phillips flat head screws and two #4-40 hex nuts. The nut carriers go inside behind the venting slots to hold the frame against