Thingiverse
Creality CR-10 Control Box 120mm Fan Mod
41
Downloads
18
Likes
0
Makes
IMPORTANT: READ THE END OF THIS FOR SAFETY INFORMATION.
Modification for the original Creality CR-10 control box; replaces the three loud fans inside with either one or two 120mm fans.
Print 2 of these stands and fit either one or both with 120mm fans (no screws required).
If you only fit one fan, I would recommend you fit the front stand with a fan blowing inwards so the air cools the power supply and goes up the box and cools both the circuit boards.
Open the control box, remove
Modification for the original Creality CR-10 control box; replaces the three loud fans inside with either one or two 120mm fans.
Print 2 of these stands and fit either one or both with 120mm fans (no screws required).
If you only fit one fan, I would recommend you fit the front stand with a fan blowing inwards so the air cools the power supply and goes up the box and cools both the circuit boards.
Open the control box, remove
Sign in to leave a comment
Sign in