Thingiverse
Wanhao Duplicator i3 / Monoprice Maker Select V2 Upgrade Part 1 - 2x30mm X-Axis / 30mm Z-Axis
by OlafB
32
Downloads
14
Likes
0
Makes
This Series will start a development of my Wanhao Duplicator i3 v2.1.
This Episode will push the X-Axis holding Frame both 30mm wider and the Bridge 30mm higher to allow further developments.
Azza´s Z-Brace will be supported.
How to:
1. The Extensions are for the right side, print them normal oder mirrored to get 4 corners.
2. You need longer M3 DIN912 Screws, M3 Washers, M3 Nuts.
3. Bring the extruder to a middle position in x und y and place something under it because we touch the
This Episode will push the X-Axis holding Frame both 30mm wider and the Bridge 30mm higher to allow further developments.
Azza´s Z-Brace will be supported.
How to:
1. The Extensions are for the right side, print them normal oder mirrored to get 4 corners.
2. You need longer M3 DIN912 Screws, M3 Washers, M3 Nuts.
3. Bring the extruder to a middle position in x und y and place something under it because we touch the
Sign in to leave a comment
Sign in