(My First Upload) 5 Inch Racing Quadcopter Propeller

5 inch propeller designed for racing quadcopter. Comparable to DAL Cyclone 5050Cx3. STL file is large because my STL tolerences in SolidWorks are low. Might upload a 2-blade version upon request. Statically-tested on 2205 motors at max throttle. No problems whatsoever.

I used concentric infill to increase strength under tension due to radial forces. Printed at 0.15 layer height and 205 degrees Celsius, 2 layer top, bottom and perimeter. Material cost with support is about 7 cents (USD) per p