Thingiverse
SD Card Adapter
by Battman540
27
Downloads
11
Likes
0
Makes
After completing my Tronxy X3 No Controller design I noticed that the SD to micro SD card adapter was just laying on the table top. I searched through Thingiverse for a design but didn't care for any that I found so I designed my own.
This is designed for 20x20 extrusion and has three variants, one left mount, a right mount and a rear mount. To attach to your printer use 4mmx10mm screw and boat nut.
Works great! I just printed four of them, one for each X3A. Now I need to print another for
This is designed for 20x20 extrusion and has three variants, one left mount, a right mount and a rear mount. To attach to your printer use 4mmx10mm screw and boat nut.
Works great! I just printed four of them, one for each X3A. Now I need to print another for
Sign in to leave a comment
Sign in