Thingiverse
CR-10 3 in 1 Windowed Extruder Cover and Slotted-Filament Guide
9
Downloads
3
Likes
0
Makes
I printed and installed this awesome accessory by member graham01.
But I wasn't able to have visibility of the extruder gear or the filament especially when loading the filament.
Most often than not, I would forget to pass the filament through the guide in the Extruder cover. As a result, I would end up not using the cover because I would have to unload the filament and then reload it again, which wasn't practical especially after the printing had commenced!
Therefore, I modified this pa
But I wasn't able to have visibility of the extruder gear or the filament especially when loading the filament.
Most often than not, I would forget to pass the filament through the guide in the Extruder cover. As a result, I would end up not using the cover because I would have to unload the filament and then reload it again, which wasn't practical especially after the printing had commenced!
Therefore, I modified this pa
Sign in to leave a comment
Sign in