Thingiverse
Peon230 Antenna Mount
by rage1618
2
Downloads
2
Likes
0
Makes
This is an antenna mount for the Peon230 3D printed quadcopter.
I needed something to support the two antennas of my FrSky reciever at 90 degrees to each other.
The mount slots in to 3 slots near the quadcopter "logo" on the top plate and is secured by zip-ties.
The two circular holes are designed to fit a 3mm straw to support the antennas or you can secure the antennas to the zip-ties.
The larger hole in the middle was intended to allow an FPV antenna to come up through the support
I needed something to support the two antennas of my FrSky reciever at 90 degrees to each other.
The mount slots in to 3 slots near the quadcopter "logo" on the top plate and is secured by zip-ties.
The two circular holes are designed to fit a 3mm straw to support the antennas or you can secure the antennas to the zip-ties.
The larger hole in the middle was intended to allow an FPV antenna to come up through the support
Sign in to leave a comment
Sign in