Thingiverse
Picture Hanger
by alterob
57
Downloads
37
Likes
0
Makes
Printed in PLA, with 33% infill this is a very sturdy picture hanger. Attach it to drywall with a common nail up to 2.5mm in diameter (13 ga.).
The fine detail in the center also makes a good test to show how acceleration, jerk, temperature, and cooling impact your prints. As a bonus, when you are done with your test you have a mess of picture hangers to use when needed.
The fine detail in the center also makes a good test to show how acceleration, jerk, temperature, and cooling impact your prints. As a bonus, when you are done with your test you have a mess of picture hangers to use when needed.
Sign in to leave a comment
Sign in