Thingiverse
Rumba Printer Motherboard TAZ mount
by superpirson
2
Downloads
1
Likes
0
Makes
This is a simple case for a Rumba 3d printer control board.
(see http://reprap.org/wiki/RUMBA)
The mounting holes are measured out to fit a Lulzbot TAZ printer. (150 mm spacing between the left and right pair of mounting holes)
The holes are set up for M3 screws and M3 thermal inserts, but using wood screws may be possible if you drill out the holes on the faceplate.
It mounts two 40mm fans, which you could get on Amazon or Ebay. These are used to cool the stepper drivers. They can be
(see http://reprap.org/wiki/RUMBA)
The mounting holes are measured out to fit a Lulzbot TAZ printer. (150 mm spacing between the left and right pair of mounting holes)
The holes are set up for M3 screws and M3 thermal inserts, but using wood screws may be possible if you drill out the holes on the faceplate.
It mounts two 40mm fans, which you could get on Amazon or Ebay. These are used to cool the stepper drivers. They can be
Sign in to leave a comment
Sign in