Z and X chain mount for Anet A8

Here's my X and Z chain mount designed to use the chains from www.thingiverse.com/thing:2193695 and others. The chain files are included from that thing.

YOU WILL NEED TO EXTEND WIRES! At least in my case I did and I made them too long.

Get the chain here: https://www.thingiverse.com/thing:3179124


I put up a notated picture to explain some of the junk hanging out on the chain mount. This is my opto isolated board for the 12v sensor and a header block to connect the extruder heaters w