Thingiverse
Z506 Speaker Mounts - Roof
by bigdiv
17
Downloads
17
Likes
0
Makes
Best printed standing ( Flat bottom ) designed to allow the supports to reach through the middle and hold the pin if required.
Installed into the rear of the speaker, which is the molding for the tweeter. It is not a port of any kind so it is fine to plug with this. Glue in place for a more permanent fit ( Is a tight fit any way )
Installed into the rear of the speaker, which is the molding for the tweeter. It is not a port of any kind so it is fine to plug with this. Glue in place for a more permanent fit ( Is a tight fit any way )
Sign in to leave a comment
Sign in