Thingiverse
Prosthetic Cover Connector
by vtcgeek
22
Downloads
25
Likes
0
Makes
This is a modification of Djoko Kuswanto's (crewolprint3d) CRE-04_Cryptec_Pattern_Leg_Prosthesis-joint_cover for attaching CRE-04_Cryptec_Pattern_Leg_Prosthesis-cover_front and rear to a standard 30mm diameter prosthetic pylon. https://www.thingiverse.com/thing:2754691
The part is a very tight fit over a standard 30mm pylon and cannot be installed by flexing the part open. A pylon adapter will have to be removed from the pylon to install the joint cover. Most pylon adapters utilize 1 or two 4
The part is a very tight fit over a standard 30mm pylon and cannot be installed by flexing the part open. A pylon adapter will have to be removed from the pylon to install the joint cover. Most pylon adapters utilize 1 or two 4
Sign in to leave a comment
Sign in