Thingiverse
Armattan Rooster TBS unify Pro HV and FC mount.
34
Downloads
22
Likes
0
Makes
TBS Unify pro HV mount with FC or 4in1 esc stack.
Placing it in the stack give it the cleanest of all the trial designs I thought up.
Notes: Best printed in ABS or high temp filament due to VTX temps
1. There is a small front to rear offset. TBS fits in one direction only.
2. Holes are 2.8mm in diameter. Run the screws back and forth while when threading.
3. Tabs on the corners may need a small bet of trimming to have perfect fit, or can chop off (not really necessary, but added.
Placing it in the stack give it the cleanest of all the trial designs I thought up.
Notes: Best printed in ABS or high temp filament due to VTX temps
1. There is a small front to rear offset. TBS fits in one direction only.
2. Holes are 2.8mm in diameter. Run the screws back and forth while when threading.
3. Tabs on the corners may need a small bet of trimming to have perfect fit, or can chop off (not really necessary, but added.
Sign in to leave a comment
Sign in