Thingiverse
Filament Clip (1.75)
by Busterific
5
Downloads
8
Likes
0
Makes
A filament clip for 1.75 filament.
Depending on printing tolerances filament should loosely snap into the open end. The hole on the closed end is not straight so should allow for more friction to prevent the clip from sliding off after the loose end of the filament has been poked through the hole.
2018-02-25: Had some issues with the open end slipping in some instances causing the spool to unwind even with the closed end gripping as intended. I've added a v2 that offsets the open hole s
Depending on printing tolerances filament should loosely snap into the open end. The hole on the closed end is not straight so should allow for more friction to prevent the clip from sliding off after the loose end of the filament has been poked through the hole.
2018-02-25: Had some issues with the open end slipping in some instances causing the spool to unwind even with the closed end gripping as intended. I've added a v2 that offsets the open hole s
Sign in to leave a comment
Sign in