IDC 2X5 pin ribbon holder for T slot

I recommend TPU .2 layer height with printed as it's orientated with the big bit face down . there is enough of a gap that bridging works fine to insert the cable.

The final iteration has one .2mm layer in the middle just cut through this bit on the base, it looks neater.


If used with the AM8 the ribbon lead is not long enough so I've ordered this

https://www.ebay.co.uk/itm/2-54mm-Pitch-10-Pin-10-Way-F-F-Connector-IDC-Flat-Rainbow-Ribbon-Cable-118cm/191634191618?ssPageName=STRK%3AMEBI