Nerf Longshot Pump Grip Rail for Worker F10555

This is a picatinny rail for the side rails on the Worker Pump Grip Kit (F10555) for the Nerf Longshot.
I would suggest that you print with 100% infill to ensure your attachments stay put while running etc.The photographed print was printed at 0.2mm

You will need three (for each side) 6mm M3 screws that will screw into the existing threaded holes on the worker rail. You must ensure the screws do not protrude from the rear of the rail to prevent scratching the blaster shell.

The Nerf elite