Thingiverse
Taranis X9D+ Power Switch
by fpvga
15
Downloads
10
Likes
0
Makes
Plastic piece of the power switch for the Taranis X9D+ SE. I just found the stock power switch super chintzy feeling, and I hate the glossy plastic. So I made a new one.
You need to open up the case, remove the power switch module, and replace the plastic switch. It should fit as is, though it appears there are a few different length switches. If it doesn't fit without creating too much pressure, you can just snip off 1-2mm from the switch itself so it fits better into the indentation in this
You need to open up the case, remove the power switch module, and replace the plastic switch. It should fit as is, though it appears there are a few different length switches. If it doesn't fit without creating too much pressure, you can just snip off 1-2mm from the switch itself so it fits better into the indentation in this
Sign in to leave a comment
Sign in