Armattan Rooster TBS style SMA mount 90 degree

Rooster TBS style SMA mount at 90 degrees (no antenna tubes on this one). I have personally printed it, and did not like the shortness of the SMA plug. Thickness of the 3d part hole is 1.5mm, anything greater and antenna does not screw down fully, but might be just a tad too thin for my liking, and could rip out the SMA in a crash.

Personally, I chopped off my TBS style and soldered on a standard style to use the other mounts I listed. Much better "bite" when tightening it to the print.