Thingiverse
15 to 12 mm thru-axle skewer insert
by aiber
21
Downloads
13
Likes
0
Makes
Endplugs for stepping from 15 to 12 mm thru-axle skewers.
Not recommended for 3D printing. Turn it on a lathe.
Drawing in inch & mm.
I listed the closest American/imperial drills for the 12 mm bore. I then used a boring bar to turn the ID to exactly 12 mm. In practice, the 15/32" drill bit worked wonderfully to start the hole.
If you are fancy, you can add o-rings like this (https://www.ebay.com/itm/J-L-15mm-12mm-Thru-Axle-Hub-Conversion-Adapter-FOR-Hope-Mavic-DT-Swiss-Shimano/201740
Not recommended for 3D printing. Turn it on a lathe.
Drawing in inch & mm.
I listed the closest American/imperial drills for the 12 mm bore. I then used a boring bar to turn the ID to exactly 12 mm. In practice, the 15/32" drill bit worked wonderfully to start the hole.
If you are fancy, you can add o-rings like this (https://www.ebay.com/itm/J-L-15mm-12mm-Thru-Axle-Hub-Conversion-Adapter-FOR-Hope-Mavic-DT-Swiss-Shimano/201740
Sign in to leave a comment
Sign in