Thingiverse
mpwr NanoX
by ebastler
13
Downloads
9
Likes
0
Makes
Some time ago I decided to design one of the smallest possible 3" FPV racers.
It fits 3" props, 13xx-14xx motors, a 20x20 FC and a runcam mikro swift (or similarly sized camera).
31*31mm hardware would fit the frame as well (45° rotated to the flying axis), my pod will not fit anymore then, as it uses the 31mm holes as mounting points.
The pod is designed to be printed using flexible filament, without supports (though it will sag a bit in the rear).
It flies amazingly well and is a lot
It fits 3" props, 13xx-14xx motors, a 20x20 FC and a runcam mikro swift (or similarly sized camera).
31*31mm hardware would fit the frame as well (45° rotated to the flying axis), my pod will not fit anymore then, as it uses the 31mm holes as mounting points.
The pod is designed to be printed using flexible filament, without supports (though it will sag a bit in the rear).
It flies amazingly well and is a lot
Sign in to leave a comment
Sign in