Thingiverse
Spitfire Caddy / Stand / Carrier
by Magnus_e
69
Downloads
45
Likes
0
Makes
I needed a nice caddy / stand / carrier for my 3d labprint Spitfire, and came up with this.
With this you do not need to disconnect the wing to transport or store your Spitfire or similar rc airplane. Just welcro it down, and off you go!
Print resolution 250um to 300um. Infill 10-15%, no supports.
You need 1meter of 32mm (1 1/2 inch) PVC / PP drain pipe. Cut it in three equal parts.
Use a velcro strap around bottom tube to hold fuselage, and a longer one on top tubes to hold the wing
With this you do not need to disconnect the wing to transport or store your Spitfire or similar rc airplane. Just welcro it down, and off you go!
Print resolution 250um to 300um. Infill 10-15%, no supports.
You need 1meter of 32mm (1 1/2 inch) PVC / PP drain pipe. Cut it in three equal parts.
Use a velcro strap around bottom tube to hold fuselage, and a longer one on top tubes to hold the wing
Sign in to leave a comment
Sign in