Thingiverse
BigSwitch + Arduino Nano + 12 2812b NeoPixel Ring Lamp
by gunkl
5
Downloads
1
Likes
0
Makes
#### BigSwitch + LED Ring + Arduino Nano Lamp
Light show lamp, press to change light modes, etc.
Use the "buttoncycler" sample from the NeoPixel library for arduino.
I made some minor changes to the code. See below.
For obvious reasons use clear or nearly clear filament.
Use the standard wiring for the LED rings, remember to add a largeish (63uF+ cap across 5V to GND supply and a 330ohm or similar resistor between D6 on the Nano and DIN on the LED ring.
Connect bigswitch pin to t
Light show lamp, press to change light modes, etc.
Use the "buttoncycler" sample from the NeoPixel library for arduino.
I made some minor changes to the code. See below.
For obvious reasons use clear or nearly clear filament.
Use the standard wiring for the LED rings, remember to add a largeish (63uF+ cap across 5V to GND supply and a 330ohm or similar resistor between D6 on the Nano and DIN on the LED ring.
Connect bigswitch pin to t
Sign in to leave a comment
Sign in