Thingiverse
18mm proximity sensor support
by kawakin
16
Downloads
7
Likes
0
Makes
This is a sensor holder with a dial adjustment for a φ18 proximity sensor that can not adjust the detection distance.
It is also effective when you are using a glass bed and the adjustment range is limited.
**Things to prepare:**
3×M3 20mm
4×M3 30-40mm
6×M3 nut
**update**
*2018/2/19*
The depth of counter bore of whirl-stop was too deep, and M3 20mm bolt stick out of the back side.
*2018/2/22*
I've modified whirl-stop part again.
It is also effective when you are using a glass bed and the adjustment range is limited.
**Things to prepare:**
3×M3 20mm
4×M3 30-40mm
6×M3 nut
**update**
*2018/2/19*
The depth of counter bore of whirl-stop was too deep, and M3 20mm bolt stick out of the back side.
*2018/2/22*
I've modified whirl-stop part again.
Sign in to leave a comment
Sign in