Thingiverse
CR-10 Filament Guide
by ts-k-s
71
Downloads
32
Likes
1
Makes
I have moved the original holder of the CR-10 upwards. Therefore, I needed a guide to guide the filament in an arc to the extruder.
Due to a wish from SLICKASICE1805 I redesigned it. Now you can use the guide in 4 in each case 90 degrees shifted positions.
Update 18-09-04:
Due to frequent filament break while the printer is not working for a long time, I changed the exit angle of the guide. Now the filament runs into the extruder at a better angle so that the filament does not break due t
Due to a wish from SLICKASICE1805 I redesigned it. Now you can use the guide in 4 in each case 90 degrees shifted positions.
Update 18-09-04:
Due to frequent filament break while the printer is not working for a long time, I changed the exit angle of the guide. Now the filament runs into the extruder at a better angle so that the filament does not break due t
Sign in to leave a comment
Sign in