Thingiverse
Thermaltake Core P5 case top panel
15
Downloads
11
Likes
0
Makes
Top panel for the Core P5 case allowing you to install the Corsair H115i radiator onto the top
The hoses on these closed loops are not long enough to fit them where they should go so i designed this to allow me to install my radiator in the top.
i designed this then had it cut from 5mm acrylic but if your print bed was big enough it could be printed too
made to be used with the panel holders from thermaltake:
http://3dmakers.thermaltake.com/dwgallery.aspx?s=164
The hoses on these closed loops are not long enough to fit them where they should go so i designed this to allow me to install my radiator in the top.
i designed this then had it cut from 5mm acrylic but if your print bed was big enough it could be printed too
made to be used with the panel holders from thermaltake:
http://3dmakers.thermaltake.com/dwgallery.aspx?s=164
Sign in to leave a comment
Sign in