Thingiverse
Snowboard Vise
by 4numen
129
Downloads
108
Likes
1
Makes
This is a 3d printable Snowboard Vise.
Store prices were ridiculous so I have designed my own.
Vise is very simple to enable fast printing & low resolution.
You will need:
-large printbed 20x25 cm (200x195 mm version now added)
-threaded bolt 10mm
-screw 17mm (optional, works without it, but once PLA thread wears out you can insert the screw-> see picture)
Ball & plate are optional, I've added them to reduce damage to the table.
I have additionally added a very thin layer of silicone
Store prices were ridiculous so I have designed my own.
Vise is very simple to enable fast printing & low resolution.
You will need:
-large printbed 20x25 cm (200x195 mm version now added)
-threaded bolt 10mm
-screw 17mm (optional, works without it, but once PLA thread wears out you can insert the screw-> see picture)
Ball & plate are optional, I've added them to reduce damage to the table.
I have additionally added a very thin layer of silicone
Sign in to leave a comment
Sign in