Thingiverse
Spooly Holdy
by marksteele
10
Downloads
3
Likes
0
Makes
Yet another spool holder. This one is fully 3d-printed, and uses a ball-less bearing for smooth rolling.
I had a 13mm dowel that I wanted to use to hold my spool, so I designed this spool holder.
The knob will fit holes 40-70mm.
The rod is 60mm long, and the knobs are 17mm, so total spool widths of up to 94mm should work.
The Loooonger rod is longer to fit bigger spools.
I had a 13mm dowel that I wanted to use to hold my spool, so I designed this spool holder.
The knob will fit holes 40-70mm.
The rod is 60mm long, and the knobs are 17mm, so total spool widths of up to 94mm should work.
The Loooonger rod is longer to fit bigger spools.
Sign in to leave a comment
Sign in