Gate Holder v2 for Arkham / Eldritch Horror

This is a remix from Mike1840858, which is a remix of Max's development McMuffin77.

Mike1840858 has a very good recycling model for printing!

But there are a few shortcomings, which I eliminated:
1. I did not like the curve of the front tentacle - a very straight angle. Not beautiful.
2. Poor end of the tentacle from behind - rests against the wall.
3. There remains an ugly bald patch from the tentacles behind.

Disk suggest printing with these settings:
Concentric infil and 40 (maxi