Thingiverse
OpenAPS edison-explorer rig case for 18650 (pre-wired ~70mm batteries)
by tynbendad
8
Downloads
4
Likes
0
Makes
(NOTE: if 3500mAh isn't enough for you, check out https://www.thingiverse.com/thing:4791313)
V4b: thickens some of the walls (fits the 3500mAH tenergy battery linked below, but if you have a longer or shorter battery you can scale both parts in the Z direction as needed). FYI: I've noticed that when using Cura, walls may not be printed with the thickness from the model - you can vary the line width in Cura to find a nearby value that prints an even number of walls it will do better (i've fou
V4b: thickens some of the walls (fits the 3500mAH tenergy battery linked below, but if you have a longer or shorter battery you can scale both parts in the Z direction as needed). FYI: I've noticed that when using Cura, walls may not be printed with the thickness from the model - you can vary the line width in Cura to find a nearby value that prints an even number of walls it will do better (i've fou
Sign in to leave a comment
Sign in