Thingiverse

Hot glue Sleeve, shell mold for JST-XH connector

by danielroibert

124 Downloads

94 Likes

0 Makes

Download Model

aeromodelisme cable protection cuff JST JST-XH Lipo modelisme protection de cbles RC-BATTERY sheath sleev sleeve aeromodelisme cable protection cuff JST JST-XH Lipo modelisme protection de cbles RC-BATTERY sheath sleev sleeve

Mold for make cable shell for JST-XH or similar connectors. It work with PETG and glue not to hot, about 170-180°C

https://www.youtube.com/watch?v=vetH_S9nsAE&t=10s

1 - Put anti-attachement in the mold.
2 - Put the JST connector in the right piece.
3 - Put a few glue in the midle pieces.
4 - Place the right pieces and the center pieces together
5 - Fill the center pieces near full
6 - Put quick and tight the left pieces
7 - Wait 5 minutes for the cooling down
8 - Turn out and remove

Source

Thingiverse

Comments