Thingiverse
CNC Drag Knife (Prototyp 5)
by erdinand3000
6
Downloads
8
Likes
0
Makes
I tested it today but doesnt work.
The weight below the bearings is too high and the idea of a pla slide axis is just not smooth enough to let it spin.
PROTO6 will deal with this problem and with the length from cut point to bearing (Scalpel blade =4cm) so the blade should fit into a bearing
18.02.
PROTO3 is enable to cut but it doesnt get the Corners right. PROTO4 will need to get a good offset setting AND blade height setting.
It uses some springs which fit between the inner and out
The weight below the bearings is too high and the idea of a pla slide axis is just not smooth enough to let it spin.
PROTO6 will deal with this problem and with the length from cut point to bearing (Scalpel blade =4cm) so the blade should fit into a bearing
18.02.
PROTO3 is enable to cut but it doesnt get the Corners right. PROTO4 will need to get a good offset setting AND blade height setting.
It uses some springs which fit between the inner and out
Sign in to leave a comment
Sign in