Thingiverse
CR10 Filament Sensor Housing
by Tacblades
60
Downloads
32
Likes
0
Makes
A new housing for the CR10S Filament Sensor
This fixes many problems with the new moulded ABS housing that is stock with the printer.
You need to buy x3 M3 x 16mm Cap head Hex bolts and x3 M3 nuts
This clamps on in the same position as the stock housing is very firm and good tolerances.
I have also included a version if you are using a bulldog extruder.
It use the stock sensor and mount screws for the sensor.
When clamping down do not tighten the clamp bolts hard at all, just nip the
This fixes many problems with the new moulded ABS housing that is stock with the printer.
You need to buy x3 M3 x 16mm Cap head Hex bolts and x3 M3 nuts
This clamps on in the same position as the stock housing is very firm and good tolerances.
I have also included a version if you are using a bulldog extruder.
It use the stock sensor and mount screws for the sensor.
When clamping down do not tighten the clamp bolts hard at all, just nip the
Sign in to leave a comment
Sign in