Thingiverse
Eachine Wizard X220 Pod (R02)
by PaddyJaki
82
Downloads
55
Likes
1
Makes
Revision 02 - (05.04.18)
Revision 01 - (07.03.18)
Revision 00 - (28.02.18)
A pod I i’ve designed for the Eachine Wizard x220.
R02 now uses bolt + nut to secure it to the bottom plate (picture 9). This is much more robust than the previous method, but will require four M3 nuts.
I have also increased the height of the pod over the stack, it was quite tough to get the fs-ia6b receiver in here on the previous version (R01).
I also increased the diameter of the RX antenna holes, from 5.
Revision 01 - (07.03.18)
Revision 00 - (28.02.18)
A pod I i’ve designed for the Eachine Wizard x220.
R02 now uses bolt + nut to secure it to the bottom plate (picture 9). This is much more robust than the previous method, but will require four M3 nuts.
I have also increased the height of the pod over the stack, it was quite tough to get the fs-ia6b receiver in here on the previous version (R01).
I also increased the diameter of the RX antenna holes, from 5.
Sign in to leave a comment
Sign in