D1M BLOCK - TP4056

This is the casing for the D1M TP4056 BLOCK; a stackable module that includes a breakout for the charging 18650 and similar batteries. The pin layout is a standard for some upcoming battery power modules for the D1M BLOCKS.

The protoboard was not used as it did not support some requirements; a 3D printed board has been used instead.

These [components](http://www.iot123.com.au/MT_D1M_TP4056), 2 off 8 pin 10mm Long Needle Female Pin Header Strip are required for this build.

[Instructions]