Thingiverse

Extrusion 4 Slot Spool Holder

by S1CAR1US

2 Downloads

0 Likes

0 Makes

Download Model

filament filament holder spool spool holder tevo tevo 3d printer tevo black widow tevo tarantula tevo tornado filament filament holder spool spool holder tevo tevo 3d printer tevo black widow tevo tarantula tevo tornado

2 VERSIONS- the one labeled with LARGE will fit a standard 1kg spool which is about 68 mm thick/wide. The smaller one is measured for some smaller spools including the ones that are broken free from the XYZ filament cartridges. I still like to use these if I need to respool some filament so that I am able to print the same stuff on two printers at once.

I made this because there just weren't any good ones yet which did not use any hardware. These have not yet been fully tested except for

Source

Thingiverse

Comments